User's Manual

Firmware Version 1.0.0.5
UCM6510 IP PBX User Manual
Page 116 of 192
RING GROUP
The UCM6510 supports ring group feature with different ring strategies applied to the ring group members.
This section describes the ring group configuration on the UCM6510.
CONFIGURE RING GROUP
Ring group settings can be accessed via web GUI->PBX->Call Features->Ring Group.
Figure 45: Ring Group
 Click on "Create New Ring Group" to add ring group.
 Click on to edit the ring group. The following table shows the ring group configuration parameters.
 Click on to delete the ring group.
Table 37: Ring Group Parameters
Ring Group Name
Configure ring group name to identify the ring group. Letters, digits, _
and - are allowed.
Extension
Configure the ring group extension.
Ring Group Members
Select available users from the left side to the ring group member list on
the right side. Click on to arrange the order.
Ring Strategy
Select the ring strategy. The default setting is "Ring in order".
 Ring simultaneously
Ring all the members at the same time when there is incoming call
to the ring group extension. If any of the member answers the call, it
will stop ringing.
 Ring in order
Ring the members with the order configured in ring group list. If the
first member doesn't answer the call, it will stop ringing the first
member and start ringing the second member.
Ring Timeout on Each Member
Configure the number of seconds to ring each member. If set to 0, it will
keep ringing. The default setting is 30 seconds.