User's Manual Part 2
Firmware Version 1.0.0.1 UCM6200 Series IP PBX User Manual Page 262 of 320
INTERNALOPTIONS
This section describes internal options that haven't been mentioned in previous sections yet. The settings
in this section can be applied globally to the UCM6200, including general configurations, jitter buffer, RTP
settings, ports config and STUN monitor. The options can be accessed via Web GUI->PBX->Internal
Options-> General.
INTERNA LOPTIONS/GENERAL
Table 76: Internal Options/General
General Preferences
Global OutBound CID
Configure the global CallerID used for all outbound calls when no other
CallerID is defined with higher priority. If no CallerID is defined for
extension or trunk, the global outbound CID will be used as CallerID.
Global OutBound CID Name
Configure the global CallerID Name used for all outbound calls. If
configured, all outbound calls will have the CallerID Name set to this
name. If not, the extension's CallerID Name will be used.
Operator Extension
Specify the operator extension, which will be dialed when users press 0 to
exit voicemail application. The operator extension can also be used in
IVR option.
Ring Timeout
Configure the number of seconds to ring an extension before the call
goes to the user's voicemail box. The default setting is 60.
Note:
This is the global value used for each extension if "Ring Timeout" field is
left empty on the extension configuration page.
Call Duration Limit Configure the maximum duration of call-blocking.
Record Prompt
If enabled, users will hear voice prompt before recording is started or
stopped. For example, before recording, the UCM6200 will play voice
prompt "The call will be recorded". The default setting is "No".
Extension Preferences
Enforce Strong Passwords
If enabled, strong password will be enforced for the password created on
the UCM6200. The default setting is enabled.
Strong Password Rules:
1. Password for voicemail, voicemail group, outbound route, DISA, call
queue and conference requires non-repetitive and non-sequential