User's Manual Part 2
Firmware Version 1.0.0.1 UCM6200 Series IP PBX User Manual Page 258 of 320
Barge Spy
This is the feature code to join in on the call to assist both parties.
The default setting is *56.
Enable Inbound Multiple Mode
If enabled, user can switch between different inbound route modes
with feature code. By default, this option is disabled.
Inbound Default Mode
This feature code is used to switch inbound route mode to default
mode. The default setting is *61.
Inbound Mode 1
This feature code is used to switch inbound route mode to mode 1.
The default setting is *62.
CALLRECORDING
The UCM6200 allows users to record audio during the call. If "Auto Record" is turned on for an extension,
ring group, call queue or trunk, the call will be automatically recorded when there is established call with it.
Otherwise, please follow the instructions below to manually record the call.
1. Make sure the feature code for "Audio Mix Record" is configured and enabled.
2. After establishing the call, enter the "Audio Mix Record" feature code (by default it's *3) followed by #
or SEND to start recording.
3. To stop the recording, enter the "Audio Mix Record" feature code (by default it's *3) followed by # or
SEND again. Or the recording will be stopped once the call hangs up.
4. The recording file can be retrieved under Web GUI->Status->CDR. Click on
to play the recording
or click on
to download the recording file.
Figure 153: Download Recording File from CDR Page