User's Manual Part 2

Firmware Version 1.0.0.1 UCM6200 Series IP PBX User Manual Page 244 of 320
--------------------------------------------------------------------------------------------------------------------------------------------
Note:
 To configure LDAP sync, please go to UCM6200 web GUI->PBX->Basic/Call Routes->VoIP Trunk.
You will see "Sync LDAP Enable" option. Once enabled, please configure password information for the
remote peer UCM6200 to connect to the local UCM6200. Additional information such as port number,
LDAP outbound rule, LDAP Dialed Prefix will also be required. Both the local UCM6200 and remote
UCM6200 need enable LDAP sync option with the same password for successful connection and
synchronization.
 Currently LDAP sync feature only works between two UCM6200s.
 (Theoretically) Remote BLF monitoring will work when the remote PBX being monitored is
non-UCM6200 PBX. However, it might not work the other way around depending on whether the
non-UCM6200 PBX supports event list BLF or remote monitoring feature.
--------------------------------------------------------------------------------------------------------------------------------------------