User's Manual Part 2

Firmware Version 1.0.0.1 UCM6200 Series IP PBX User Manual Page 222 of 320
FAX/T.38
The UCM6200 supports T.30/T.38 Fax and Fax Pass-through. It can convert the received Fax to PDF
format and send it to the configured Email address. Fax/T.38 settings can be accessed via Web
GUI->PBX->Internal Options->FAX/T.38. The list of received Fax files will be displayed in the same web
page for users to view, retrieve and delete.
CONFIGUREFAX/T.38
 Click on "Create New Fax Extension". In the popped up window, fill the extension, name and Email
address to send the received Fax to.
 Click on "Fax Settings" to configure the Fax parameters.
Table 69: FAX/T.38 Settings
Enable Error Correction Mode
Configure to enable Error Correction Mode (ECM) for the Fax. The default
setting is "Yes".
Maximum Transfer Rate
Configure the maximum transfer rate during the Fax rate negotiation. The
possible values are 2400, 4800, 7200, 9600, 12000 and 14400. The
default setting is 14400.
Minimum Transfer Rate
Configure the minimum transfer rate during the Fax rate negotiation. The
possible values are 2400, 4800, 7200, 9600, 12000 and 14000. The
default setting is 2400.
Max Concurrent Sending Fax
Configure the concurrent fax that can be sent by UCM6200. Two mode
“Only” and “More” are supported.
 Only
Under this mode, the UCM6200 allows only single user to send fax at
a time.
 More
Under this mode, the UCM6200 supports multiple concurrent fax
sending by the users.
By default, this option is set to “only”.
Fax Queue Length
Configure the maximum length of Fax Queue from 6 to 10. The default
setting is 6.
Default Email Address
Configure the Email address to send the received Fax to if user's Email
address cannot be found.
Note: