User's Manual Part 2

Firmware Version 1.0.0.1 UCM6200 Series IP PBX User Manual Page 173 of 320
 Click on to delete the inbound route.
INBOUNDRULECONFIGURATIONS
Table 57: Inbound Rule Configuration Parameters
Trunks
Select the trunk to configure the inbound rule.
DID Pattern
 All patterns are prefixed with the "_".
 Special characters:
X: Any Digit from 0-9.
Z: Any Digit from 1-9.
N: Any Digit from 2-9.
".": Wildcard. Match one or more characters.
"!": Wildcard. Match zero or more characters immediately.
Example: [12345-9] - Any digit from 1 to 9.
 The pattern can be composed of two parts, divided by a ‘/’ character.
The first part is used to specify the dialed number the second part is
used to specify the caller ID and it is optional, if set it means only the
extension with the specific caller ID is allowed to call in or call out.
For example, patter '_2XXX/1234' means the only extension with the
caller ID '1234' is allowed to use this rule.
Prepend Trunk Name
Prepend trunk name to display
Alert-Info
Configure the Alert-Info, when UCM6200 receives an INVITE request, the
Alert-Info header field specifies an alternative ring tone to the UAS.
Inbound Multiple Mode
Multiple mode allows user to switch between destinations of the inbound
rule by feature codes. Configure related feature codes in the “Feature
Codes” page. If this option is enabled, user can use feature code to
switch between different destinations.
Default Destination
Select the default destination for the inbound call.
 Extension
 Voicemail
 Conference Room
 Queue
 Ring Group
 Paging/Intercom
 Voicemail Group
 Fax
 DISA
 IVR
 Dial By Name