User's Manual Part 2
Firmware Version 1.0.0.1 UCM6200 Series IP PBX User Manual Page 314 of 320
SYSLOG
On the UCM6200, users could dump the syslog information to a remote server under Web
GUI->Maintenance->Syslog. Enter the syslog server hostname or IP address and select the module/level
for the syslog information.
The default syslog level for all modules is "error", which is recommended in your UCM6200 settings
because it can be helpful to locate the issues when errors happen.
Some typical modules for UCM6200 functions are as follows and users can turn on "notic" and "verb"
levels besides "error" level.
pbx: This module is related to general PBX functions.
chan_sip: This module is related to SIP calls.
chan_dahdi: This module is related to analog calls (FXO/FXS).
app_meetme: This module is related to conference bridge.
--------------------------------------------------------------------------------------------------------------------------------------------
Note:
Syslog is usually for debugging and troubleshooting purpose. Turning on all levels for all syslog modules is
not recommended for daily usage. Too many syslog print might cause traffic and affect system
performance.
--------------------------------------------------------------------------------------------------------------------------------------------
TROUBLESHOOTING
On the UCM6200, users could capture traces, ping remote host and traceroute remote host for
troubleshooting purpose under Web GUI->Maintenance->Troubleshooting.
ETHERNETCAPTURE
The captured trace can be downloaded for analysis. Also the instructions or result will be displayed in the
web GUI output result.