User's Manual Part 2

Firmware Version 1.0.0.1 UCM6200 Series IP PBX User Manual Page 293 of 320
 Detect Cycle: The UCM will detect the event at each cycle based on the specified time. Users can
enter the number and then select second(s)/minute(s)/hour(s)/day(s) to configure the cycle.
Click on the switch
to turn on/off the alert and Email notification for the event. Users
could also select the checkbox for each event and then click on button "Alert On", "Alert Off", "Email
Notification On", "Email Notification Off" to control the alert and Email notification configuration.
ALERTLOG
Under Web GUI->Status->System Events->Alert Log, system messages from triggered system events
are listed as alert logs. The following screenshot shows system crash alert logs.
Figure 175: System Events->Alert Log
User could also filter alert logs by selecting a certain event category, type of alert log, and/or specifying a
certain time period. The matching results will be displayed after clicking on
. Alert logs are
classified into two types by the system:
1. Generate Alert: Generated when alert events happen, for example, alert logs for disk usage
exceeding the alert threshold.
2. Restore to Normal: Generated when alert events being cleared, for example, logs for disk usage
dropping back below the alert threshold.
User could filter out alert logs of “Generate Alert” or “Restore to Normal” by specifying the type according
to need. The following figure shows an example of filtering out alert logs of type of “Restore to Normal”.