User's Manual Part 2
Firmware Version 1.0.0.1 UCM6200 Series IP PBX User Manual Page 278 of 320
VALUE‐ADDEDFEATURES
FAXSENDING
The UCM6200 supports sending Fax via web UI access. This feature can be found on web
UI->PBX->Value-added Features->Fax Sending page. In order to send fax, pre-setup for analog trunk
and outbound route is required. Please refer to [ANALOG TRUNKS], [VOIP TRUNKS] and [OUTBOUND
ROUTES] sections for configuring analog trunk and outbound route.
After making sure analog trunk or VoIP Trunk is setup properly and UCM6200 can reach out to PSTN
numbers via the trunk, on Fax Sending page, enter the fax number and upload the file to be faxed. Then
click on “Send” to start. The progress of sending fax will be displayed in web UI. Users can also view the
sending history is in the same web page.
Figure 157: Fax Sending in Web UI
ANNOUNCEMENTSCENTER
The UCM6200 supports Announcements Center feature which allows users to pre-record and store voice
message into UCM6200 with a specified code. The users can also create group with specified extensions.
When the code and the group number are dialed together in the combination of code + group number,
the specified voice message is sent to all group members and only extensions in the group will hear the
voice message.