User's Manual Part 2

Firmware Version 1.0.0.1 UCM6200 Series IP PBX User Manual Page 276 of 320
PORTSCONFIG
The analog hardware (FXS port and FXO port) on the UCM6200 will be listed in this page. Click on to
edit signaling preference for FXS port or configure ACIM settings for FXO port.
Select "Loop Start" or "Kewl Start" for each FXS port. And then click on "Update" to save the change.
Figure 155: FXS Ports Signaling Preference
For FXO port, users could manually enter the ACIM settings by selecting the value from dropdown list for
each port. Or users could click on "Detect" for the UCM6200 to automatically detect the ACIM value. The
detecting value will be automatically filled into the settings.
Figure 156: FXO Ports ACIM Settings
Table 89: Internal Options/Ports Config
Tone Region
Select country to set the default tones for dial tone, busy tone, ring tone
and etc to be sent from the FXS port. The default setting is "United States
of America (USA)".
Advanced Settings
FXO Opermode Select country to set the On Hook Speed, Ringer Impedance, Ringer