User's Manual Part 2

Firmware Version 1.0.0.1 UCM6200 Series IP PBX User Manual Page 270 of 320
SIPSETTINGS
The UCM6200 SIP global settings can be accessed via Web GUI->PBX->SIP Settings.
SIPSETTINGS/GENERAL
Table 83: SIP Settings/General
Realm For Digest
Authentication
Configure the host name or domain name for the UCM6200. Realms
MUST be globally unique according to RFC3261. The default setting is
Grandstream.
Bind UDP Port Configure the UDP port used for SIP. The default setting is 5060.
Bind IP Address
Configure the IP address to bind to. The default setting is 0.0.0.0, which
means binding to all addresses.
Allow Guest Calls
If enabled, the UCM6200 allows unauthorized INVITE coming into the
PBX and the call can be made. The default setting is "No".
Warning:
Please be aware of the potential security risk when enabling "Allow Guest
Calls" as this will allow any user with the UCM6200 address to dial into
the UCM6200.
Allow Transfer
If set to "No", all transfers initiated by the endpoint in the UCM6200 will be
disabled (unless enabled in peers or users). The default setting is "Yes".
MWI From
When sending MWI NOTIFY requests, this value will be used in the
"From:" header as the "name" field. If no "From User" is configured, the
"user" field of the URI in the "From:" header will be filled with this value.
SIPSETTINGS/MISC
Table 84: SIP Settings/Misc
Outbound SIP Registrations
Register Timeout Configure the register retry timeout (in seconds). The default setting is 20.
Register Attempts
Configure the number of registration attempts before the UCM6200 gives
up. The default setting is 0, which means the UCM6200 will keep trying
until the server side accepts the registration request.
Video
Max Bit Rate (kb/s)
Configure the maximum bit rate (in kb/s) for video calls. The default
setting is 384.