User's Manual Part 1

Firmware Version 1.0.0.1 UCM6200 Series IP PBX User Manual Page 89 of 320
When the phone boots up, it sends out mDNS query to get the TFTP server address. The UCM6200
will respond with its own address. The phone will then send TFTP request to download the XML config
file from the UCM6200.
To start the auto provisioning process, under Web GUI->PBX->Zero Config->Zero Config Settings, fill in
the auto provision information.
Figure 63: Auto Provision Settings
Table 24: Auto Provision Settings
Enable Zero Config
Enable or disable the zero config feature on the PBX. The default setting
is enabled.
Enable Automatic
Configuration Assignment
By default, this is disabled. If disabled, when SIP device boots up, the
UCM6200 will not send the SIP device the URL to download the config file
and therefore the SIP device will not be automatically provisioned by the
UCM6200.
Note:
When disabled, SIP devices can still be provisioned by manually sending
NOTIFY from the UCM6200 which will include the XML config file URL for
the SIP device to download.
Automatically Assign
Extension
If enabled, when the device is discovered, the PBX will automatically
assign an extension within the range defined in "Zero Config Extension
Segment" to the device. The default setting is disabled.
Zero Config Extension
Click on the link "Zero Config Extension Segment" to specify the