User's Manual Part 1

Firmware Version 1.0.0.1 UCM6200 Series IP PBX User Manual Page 133 of 320
Ring Timeout
Configure the number of seconds to ring the user before the call is
forwarded to voicemail (voicemail is enabled) or hang up (voicemail is
disabled). If not specified, the default ring timeout is 60 seconds on the
UCM6200, which can be configured in the global ring timeout setting
under web GUI->Internal Options->IVR Prompt: General Preference. The
valid range is between 5 seconds and 600 seconds.
Note:
If the end point also has a ring timeout configured, the actual ring timeout
used is the shortest time set by either device.
Auto Record
Enable automatic recording for the calls using this extension. The default
setting is disabled. The recording files can be accessed under web
GUI->CDR->Recording Files.
Skip Trunk Auth
 If set to “Yes”, users can skip entering the password when making
outbound calls.
 If set to “By Time”, users can skip entering the password when
making outbound calls during the selected time condition.
 If set to “No”, users will be asked to enter the password when making
outbound calls.
Time Condition for Skip
Trunk Auth
If “Skip Trunk Auth” is set to “By Time”, select a time condition during
which users can skip entering password when making outbound calls.
Dial Trunk Password
Configure personal password when making outbound calls via trunk.
Enable LDAP
If enabled, this extension will be added to LDAP Phonebook PBX list; if
disabled, this extension will be skipped when creating LDAP Phonebook.
Music On Hold
Select which Music On Hold class to suggest to extension when putting
the active call on hold.
Call Duration Limit
Configure the maximum duration of call-blocking.
Table 44: FXS Extension Configuration Parameters->Specific Time
Specific Time
Time Condition
Click to add Time Condition to configure specific time for this extension.
BAT CHADDEXTENSIONS
BATCHADDSIPEXTENSIONS
In order to add multiple SIP extensions, BATCH add can be used to create standardized SIP extension
accounts. However, unique extension user name can’t be set using BATCH add.
Under Web GUI->PBX->Basic/Call Routes->Extensions, click on "Batch Add Extensions"->"Batch Add
SIP Extensions".