User's Manual Part 1
Firmware Version 1.0.0.1  UCM6200 Series IP PBX User Manual  Page 119 of 320
Click on the tag to view or edit options belonging to that category. 
The configuration parameters are as follows. 
Table 33: SIP Extension Configuration Parameters->Basic Settings 
General 
Extension 
The extension number associated with the user. 
CallerID Number 
Configure the CallerID Number that would be applied for outbound calls 
from this user. 
Note: 
The ability to manipulate your outbound Caller ID may be limited by your 
VoIP provider. 
Permission 
Assign permission level to the user. The available permissions are 
"Internal", "Local", "National" and "International" from the lowest level to 
the highest level. The default setting is "Internal". 
Note: 
Users need to have the same level as or higher level than an outbound 
rule's privilege in order to make outbound calls using this rule.   
SIP/IAX Password 
Configure the password for the user. A random secure password will be 
automatically generated. It is recommended to use this password for 
security purpose. 
Auth ID 
Configure the authentication ID for the user. If not configured, the 
extension number will be used for authentication. 
Enable Voicemail 
Enable voicemail for the user. The default setting is "Yes". 
Voicemail Password 
Configure voicemail password (digits only) for the user to access the 
voicemail box. A random numeric password is automatically generated. It 
is recommended to use the random generated password for security 
purpose. 
Skip Voicemail Password 
Verification 
When user dials voicemail code, the password verification IVR is skipped. 
If enabled, this would allow one-button voicemail access. By default this 
option is disabled. 
Disable This Extension 
If selected, this extension will be disabled on the UCM6200. 
Note: 
The disabled extension still exists on the PBX but can’t be used on the 
end device. 
User Settings 
First Name 
Configure the first name of the user. The first name can contain 
characters, letters, digits and _. 
Last Name 
Configure the last name of the user. The last name can contain 










