User Manual and Operating Guide

Epygi Technologies Configuring Grandstream IP Phones on Quadro LAN
3 Auto-Configuration on Grandstream IP Phones
The following step-by-step instructions describe how to configure an IP line to allow Grandstream
SIP phones to be auto-configured.
1. Log into the Quadro as an administrator.
2. Open the TelephonyÆLine SettingsÆIP Line Settings page (see
Figure 2).
Figure 2-Line Settings page
3. From the Attached Extension column, choose an extension to be assigned to the SIP
phone and click on the corresponding IP line link. Note that the table lists only the
extensions attached to IP lines. If the extension is not listed on this page, open
UsersÆExtensions Settings page and attach an IP line to the extension by editing the
extension settings (see
Figure 3).
PAGE 5 27-Sep-07