user manual

Firmware version 1.0.0.8 DP715/DP710 User Manual Page 38 of 52
Handset Status
Displays relevant information regarding the Handset status.
Handset
Hook
SIP
Registration
DND
Forward
Busy
Forward
Delayed
Forward
Handset 1
On Hook
Registered
Yes
613
• Handset 1 is registered with SIP Server.
• Handset 1 user has set Do Not Disturb.
• Handset 1 user has set his calls to be unconditionally forwarded to ext 613.
• Handset 1 user has not set Busy or Delay call Forward.
Core Dump
Download core dump file for troubleshooting when necessary.
ADVANCED USER CONFIGURATION
Log in to the advanced user configuration page the same way as for the basic configuration page. The
password is case sensitive and the factory default password for Advanced User is “admin”.
Advanced User configuration includes the end user configuration and the advanced configurations
including: a) SIP configuration, b) Codec selection, c) NAT Traversal Setting and d) other miscellaneous
configuration. DP715 has two (2) profiles for the five (5) Handsets.
Table 13: ADVANCED SETTINGS
Admin Password
This contains the password to access the Advanced Web Configuration page. This field is
case sensitive. Only the administrator can configure the “Advanced Settings” page.
Password field is purposely left blank for security reasons after clicking update and saved.
The maximum password length is 25 characters.
Layer 3 QoS
This field defines the layer 3 QoS parameter which can be the value used for IP
Precedence or Diff-Serv or MPLS. Default value is 48.
Layer 2 QoS
Value used for layer 2 VLAN tag. Default setting is blank.
STUN Server
IP address or Domain name of the STUN server.
Keep-alive interval
This parameter specifies how often the DP715 sends a blank UDP packet to the SIP
server in order to keep the “hole” on the NAT open. Default is 20 seconds. Minimum
value is 20 seconds.
Use STUN to detect
network connectivity
Use STUN keep-alive to detect WAN side network problems. If keep-alive request does
not yield any response for configured number of times, the device will restart the TCP/IP
stack. If the STUN server does not respond when the device boots up, the feature is
disabled. Default setting is No.
Firmware Upgrade
and Provisioning
Enables DP715 to download firmware or configuration file through either TFTP, HTTP or
HTTPS server.