User's Manual

P a g e | 18
HT812/HT814 User Guide
05
“DNS Server “ + IP address
Same as menu 02
07
Preferred Vocoder
Press “9” to move to the next selection in the list:
 PCMU / PCMA
 iLBC
 G-726
 G-723
 G-729
10
“MAC Address”
Announces the Mac address of the unit.
13
Firmware Server IP Address
Announces current Firmware Server IP address.
Enter 12 digit new IP address.
14
Configuration Server IP
Address
Announces current Config Server Path IP address.
Enter 12 digit new IP address.
15
Upgrade Protocol
Upgrade protocol for firmware and configuration update.
Press “9” to toggle between TFTP / HTTP / HTTPS
16
Firmware Version
Announces Firmware version information.
17
Firmware Upgrade
Firmware upgrade mode. Press “9” to toggle among the
following three options:
- Always check
- Check when pre/suffix changes
- Never upgrade
47
“Direct IP Calling”
Enter the target IP address to make a direct IP call, after
dial tone. (See “Make a Direct IP Call”.)
86
Voice Mail
Number of Voice Mails
99
“RESET”
Press “9” to reboot the device
Enter MAC address to restore factory default setting
(See Restore Factory Default Setting section)
“Invalid Entry”
Automatically returns to main menu
“Device not registered”
This prompt will be played immediately after off hook If
the device is not register and the option “Outgoing Call
without Registration” is in NO
Five success tips when using the voice prompt
 “*” shifts down to the next menu option and “#” returns to the main menu
 “9” functions as the ENTER key in many cases to confirm or toggle an option.
 All entered digit sequences have known lengths - 2 digits for menu option and 12 digits for IP
address. For IP address, add 0 before the digits if the digits are less than 3 (i.e. - 192.168.0.26
should be key in like 192168000026. No decimal is needed).