Manualshelf

User's Manual

ManualsBrandsGrandstream Networks ManualsElectronicsAnalog Telephone Adapter
21222324252627282930
FIRMWARE VERSION 1.0.0.5 HT802 USER MANUAL Page 27 of 46
to 15 or 20 minutes.
Via HTTP / HTTPS
Server
The URL for the HTTP/HTTPS server used for firmware upgrade and configuration via
HTTP.
For example, http://provisioning.mycompany.com:6688/Grandstream/1.0.0.67―:6688‖ is
the specific TCP port where the HTTP or HTTPS server is listening; it can be omitted if
using default port 80.
Note: If Auto Upgrade is set to No, HT802 will only do HTTP/HTTPS download once at
boot up.
Firmware Server Path
IP address or domain name of firmware server.
Config Server Path
IP address or domain name of configuration server.
XML Config File
Password
The password used for encrypting the XML configuration file using OpenSSL.
This is required for the phone to decrypt the encrypted XML configuration file.
HTTP/HTTPS User
Name
The user name needed to authenticate with the HTTP/HTTPS server.
HTTP/HTTPS
Password
The password needed to authenticate with the HTTP/HTTPS server.
Firmware File Prefix
Default is blank. If configured, HT802 will request firmware file with the prefix. This
setting is useful for ITSPs. End user should keep it blank.
Firmware File Postfix
Default is blank. End user should keep it blank.
Config File Prefix
Default is blank. End user should keep it blank.
Config File Postfix
Default is blank. End user should keep it blank.
Allow DHCP Option 66
to override server
If set to ―Yes‖, configuration and upgrade server information can be obtained using DHCP
option 66 from DHCP server located in customer‘s environment. Default setting is Yes.
Automatic Upgrade
Choose ―Yes” to enable automatic upgrade and provisioning. If select ―Check every
minutes‖ input the amount of minutes you want it to check for update. If select ―Yes, daily
at hour‖ make sure to input the hour of the day you want it to check for update, e.g. for 11
pm type 23. If select ―Yes, weekly on day‖ make sure you input the day of the week (in
format 0-6, 0 is Sunday) you want it to check for update. When set to No, HT802 will only
do the following option you select; ―Always check for New Firmware at Boot up‖ will check
for new firmware every time the device reboots. ―Check New Firmware only when F/W
pre/suffix changes‖ will check for updates only when the pre/suffix has been changed.