User's Manual

FIRMWARE VERSION 1.0.0.5 HT802 USER MANUAL Page 22 of 46
2. Open a web browser, type the IP address. You will see the log in page of the device.
Note:
• The IVR announces 12 digits IP address, you need to strip out the leading ―0‖ in the IP address.
For ex. IP address: 192.168.001.014, you need to type in http://192.168.1.14 in the web browser.
Once the HTTP request is entered and sent from a web browser, the user will see a log-in screen. There
are two default passwords for the login page:
User Level:
Password:
Web pages allowed:
End User Level
123
Only Status and Basic Settings
Administrator Level
Check with your service provider
Browse all pages
The password is case sensitive with maximum length of 25 characters. The factory default password for
End User and administrator is ―123‖ and ―admin‖ respectively. Only an administrator can access the
―ADVANCED SETTING‖, ―FXS PORTs‖ configuration pages.
NOTE: HT802 has factory configuration with random administrator password. Check with your service
provider for more information.
IMPORTANT SETTINGS
The end-user must configure the following settings according to the local environment.
NOTE: Most settings on the web configuration pages are set to the default values.
NAT SETTINGS
If you plan to keep the Handy Tone within a private network behind a firewall, we recommend using
STUN Server. The following three (3) settings are useful in the STUN Server scenario:
1. STUN Server (under Advanced Settings webpage)
Enter a STUN Server IP (or FQDN) that you may have, or look up a free public STUN Server on the
internet and enter it on this field. If using Public IP, keep this field blank.
2. Use Random SIP/RTP Ports (under Advanced Settings webpage)
This setting depends on your network settings. Generally if you have multiple IP devices under the
same network, it should be set to Yes. If using a Public IP address, set this parameter to No.
3. NAT Traversal (under the FXS/Profile web page)