User's Manual

FIRMWARE VERSION 1.0.0.5 HT802 USER MANUAL Page 13 of 46
BASIC OPERATIONS
UNDERSTANDING HT802 VOICE PROMPT
HT802 has a built-in voice prompt menu for simple device configuration. The IVR menu and the LED
button work with any of the FXS port. Pick up the handset and dial ―***‖ to use the IVR menu.
TABLE 5: HT802 IVR MENU DEFINITIONS
MENU
VOICE PROMPT
OPTIONS
Main Menu
―Enter a Menu Option‖
Press ―*‖ for the next menu option
Press ―#‖ to return to the main menu
Enter 01-05, 07,10, 13-17,47 or 99 menu options
01
―DHCP Mode‖,
―Static IP Mode‖
Press ―9‖ to toggle the selection
If using ―Static IP Mode‖, configure the IP address information using
menus 02 to 05.
If using ―Dynamic IP Mode‖, all IP address information comes from
the DHCP server automatically after reboot.
02
―IP Address ― + IP address
The current WAN IP address is announced
If using ―Static IP Mode‖, enter 12 digit new IP address. You need to
reset the HT for the new IP address to take Effect.
03
―Subnet ― + IP address
Same as menu 02
04
―Gateway ― + IP address
Same as menu 02
05
―DNS Server ― + IP address
Same as menu 02
07
Preferred Vocoder
Press ―9‖ to move to the next selection in the list:
 PCM U / PCM A
 iLBC
 G-726
 G-723
 G-729
10
―MAC Address‖
Announces the Mac address of the unit.
13
Firmware Server IP
Address
Announces current Firmware Server IP address. Enter 12 digit new
IP address.
14
Configuration Server IP
Address
Announces current Config Server Path IP address. Enter 12 digit
new IP address.
15
Upgrade Protocol
Upgrade protocol for firmware and configuration update. Press ―9‖ to
toggle between TFTP / HTTP / HTTPS