User's Manual
Table Of Contents
- DOCUMENT PURPOSE
- CHANGE LOG
- GUI INTERFACE EXAMPLES
- WELCOME
- PRODUCT OVERVIEW
- GETTING STARTED
- CONFIGURATION GUIDE
- Obtain HT801 IP Address via Connected Analogue Phone
- Understanding HT801 Interactive Voice Prompt Response Menu
- Configuration via Web Browser
- Web Configuration Pages Definitions
- NAT Settings
- DTMF Methods
- Preferred Vocoder (Codec)
- Configuring HT801 Through Voice Prompts
- Register a SIP Account
- Call Features
- Rebooting HT801 from Remote
- UPGRADING AND PROVISIONING
- RESTORE FACTORY DEFAULT SETTINGS
- EXPERIENCING HT801
P a g e | 40
HT801 Administration Guide
After applying your configuration, your account will register to your SIP Server, you can verify if it has been
correctly registered with your SIP server from your HT801 web interface under Status > Port Status >
Registration (If it displays Registered, it means that your account is fully registered, otherwise it will display
Not Registered so in this case you must double check the settings or contact your provider).
Figure 9: Account Status
Call Features
The HT801 supports all the traditional and advanced telephony features.
Table 10: HT801 Call Features
Key
Call features
*02
Forcing a Codec (per call) *027110 (PCMU), *027111 (PCMA), *02723 (G723), *02729
(G729), *0272616 (G726-r16), *0272624 (G724-r24), *0272632 (G726-r32), *0272640
(G726-r40), *027201 (iLBC), *027202 (OPUS).
*03
Disable LEC (per call) Dial “*03” +” number ”. No dial tone is played in the middle.
*16
Enable SRTP .
*17
Disable SRTP.
*30
Block Caller ID (for all subsequent calls).
*31
Send Caller ID (for all subsequent calls).
*47
Direct IP Calling. Dial “*47” + “IP address”. No dial tone is played in the middle.