User's Manual
Table Of Contents
- DOCUMENT PURPOSE
- CHANGE LOG
- GUI INTERFACE EXAMPLES
- WELCOME
- PRODUCT OVERVIEW
- GETTING STARTED
- CONFIGURATION GUIDE
- Obtain HT801 IP Address via Connected Analogue Phone
- Understanding HT801 Interactive Voice Prompt Response Menu
- Configuration via Web Browser
- Web Configuration Pages Definitions
- NAT Settings
- DTMF Methods
- Preferred Vocoder (Codec)
- Configuring HT801 Through Voice Prompts
- Register a SIP Account
- Call Features
- Rebooting HT801 from Remote
- UPGRADING AND PROVISIONING
- RESTORE FACTORY DEFAULT SETTINGS
- EXPERIENCING HT801
P a g e | 23
HT801 Administration Guide
Firmware File
Prefix
Checks if firmware file is with matching prefix before downloading it. This field enables
user to store different versions of firmware files in one directory on the firmware server.
Firmware File
Postfix
Checks if firmware file is with matching postfix before downloading it. This field enables
user to store different versions of firmware files in one directory on the firmware server.
Config File
Prefix
Checks if configuration files are with matching prefix before downloading them. This
field enables user to store different configuration files in one directory on the
provisioning server.
Config File
Postfix
Checks if configuration files are with matching postfix before downloading them. This
field enables user to store different configuration files in one directory on the
provisioning server.
Allow DHCP
Option 66 to
Override Server
Obtains configuration and upgrade server’s information using options 66 from DHCP
server.
Note: If DHCP Option 66 is enabled, the HT801 will attempt downloading the firmware file
from the server URL provided by DHCP, even though Config Server Path is left blank
3CX Auto
Provision
Sends multicast “SUBSCRIBE” message for provisioning at booting stage, used for PnP
(Plug-and-Play) configuration. Default is Yes.
Automatic
Upgrade
Specifies when the firmware upgrade process will be initiated; there are 4 options:
No: The HT801 will only do upgrade once at boot up. Default is No.
Check every X minutes: User needs to specify a period in minutes.
Check every day: User needs to specify “Hour of the day (0-23)”.
Check every week: User needs to specify “Hour of the day (0-23)” and “Day of
the week (0-6)”. (Day of week is starting from Sunday).
Always Check for
New Firmware at
Boot up
Configures the HT801 to always search the new firmware at boot up.
Check New
Firmware only
when F/W
pre/suffix changes
Permits the HT801 to search for the new firmware when the firmware prefix / suffix
changes.
Always Skip the
Firmware Check
Configures the HT801 to skip the firmware check.
Disable SIP
NOTIFY
Authentication
Disables the SIP NOTIFY Authentication on the phone. If set to “Yes”, the phone will not
challenge NOTIFY with 401. The default setting is “No”