User's Manual

Grandstream Networks, Inc. HT701 User Manual Page 23 of 34
Firmware Version 1.0.4.2 Last Updated: 06/2011
HTTP/HTTPS
Password
The password for the HTTP/HTTPS server.
Firmware File Prefix Default is blank. If configured, HT701 will request firmware file with the prefix. This
setting is useful for ITSPs. End user should keep it blank.
Firmware File Postfix Default is blank. End user should keep it blank.
Config File Prefix Default is blank. End user should keep it blank.
Config File Postfix Default is blank. End user should keep it blank.
Allow DHCP Option 66
to override server
If set to “Yes”, configuration and upgrade server information can be obtained using DHCP
option 66 from DHCP server located in customer’s environment.
Automatic Upgrade
Choose “Yes” to enable automatic upgrade and provisioning. If select “Check every
minutes” input the amount of minutes you want it to check for update. If select “Yes, daily at
hour” make sure to input the hour of the day you want it to check for update, e.g. for 11 pm
type 23. If select “Yes, weekly on day” make sure you input the day of the week (in format
0-6, 0 is Sunday) you want it to check for update. When set to No, HT701 will only do the
following option you select; “Always check for New Firmware at Boot up” will check for new
firmware every time the device reboots. “Check New Firmware only when F/W pre/suffix
changes” will check for updates only when the pre/suffix has been changed.
Firmware Key
Used for firmware encryption. Should be 32 digit in hexadecimal representation. End
user should keep it blank.
Authenticate Conf File
If set to Yes, config file is authenticated before acceptance. This protects the
configuration from an unauthorized change.
Firmware Key
Used for firmware encryption. Should be 32 digit in hexadecimal representation. End
user should keep it blank.
SSL Certificate
The user specify SSL certificate used for SIP over TLS in X.509 format.
SSL Private Key
The user specify SSL private key used for SIP over TLS in X.509 format.
SSL Private Key
Password
User specify password to protect the private key above.
ACS URL
User specify the Auto Configuration Server’s URL (TR-069 protocol)
ACS Username
User specify the ACS Username
ACS Password
User specify the ACS password
Periodic Inform
Enable
Default is No. If set to YES, device will send inform packets to the ACS
Periodic Inform
Interval
Frequency that the inform packets will be sent out to the ACS
Connection Request
Username
Set a user name for the ACS to connect to this device
Connection Request
Password
Set a password for the ACS to connect to this device
System Ring Cadence
Configuration option is set ring cadence on all FXS ports for all incoming calls. (Syntax:
c=on1/off1-on2/off2-on3/off3; [...]) Default is set to c=2000/4000; (US standards)