User's Manual

Grandstream Networks, Inc. HT701 User Manual Page 19 of 34
Firmware Version 1.0.4.2 Last Updated: 06/2011
Web Port
By default, HTTP uses port 80. This field is for customizable web port.
Telnet Server
Default is set to YES.
IP Address
There are two modes to operate the HT701:
DHCP mode: all the field values for the Static IP mode are not used (even though they are
still saved in the Flash memory.) The HT701 acquires its IP address from the first DHCP
server it discovers from the LAN it is connected. Using the PPPoE feature: set the
PPPoE account settings. The HT701 will establish a PPPoE session if any of the PPPoE
fields is set.
Static IP mode: configure the IP address, Subnet Mask, Default Router IP address,
DNS Server 1 (primary), DNS Server 2 (secondary) fields. These fields are set to zero by
default.
DHCP hostname Default is blank. This option specifies the name of the client. This field is optional but may
be required by some Internet Service Providers.
DHCP domain Default is blank. This option specifies the domain name that client should use when
resolving hostnames via the Domain Name System.
DHCP vendor class ID
Used by clients and servers to exchange vendor-specific information..
PPPoE account ID
PPPoE username. Necessary if ISP requires you to use a PPPoE (Point to Point Protocol
over Ethernet) connection.
PPPoE password
PPPoE account password.
PPPoE Service Name Default is blank. This field is optional. If your ISP uses a service name for the PPPoE
connection, enter the service name here.
Time Zone Controls how the date/time is displayed according to the specified time zone.
Self Defined Time Zone The syntax is std offset dst [offset],start[/time],end[/time]
Default is set to : MTZ+6MDT+5,M3.2.0,M11.1.0
MTZ+6MDT+5,
Time zone with 6 hours offset with 1 hour ahead which is the US central time. It is positive
(+) if the local time zone is west of the Prime Meridian and negative (-) if it is east.
Prime Meridian (a.k.a: International or Greenwich Meridian)
M3.2.0,M11.1.0
The 1
st
number indicates Month: 1,2,3,..,12 (for Jan, Feb, .., Dec)
The 2
nd
number indicates the n
th
iteration of the weekday: (1st Sunday, 3rd Tuesday etc)
The 3
rd
number indicates Weekday: 0,1, 2, ..,6(for Sun, Mon, Tue, .., Sat)
Therefore, this example is the DST which starts from the second Sunday of March to the
1st Sunday of November.
Language
Languages supported with voice prompt and web interface, except Spanish that it is only
in IVR.
Device Mode
This parameter controls whether the device is working in NAT router mode or Bridge
mode. Save the setting and reboot prior to configuring HT701.
NAT Maximum Ports
The number of ports that can be managed while in NAT router mode.
Range: 0 – 4096, default is 1024. Typically one port per connection.
NAT TCP Timeout
NAT TCP idle timeout in seconds. Connection will be closed after preconfigured, timeout
if not refreshed. Range: 0 - 3600