Instruction Manual

FIRMWARE VERSION 1.0.9.1 HT503 USER MANUAL Page 35 of 59
XML Config File
Password
The password used for encrypting the XML configuration file using OpenSSL.
This is required for the phone to decrypt the encrypted XML configuration file.
HTTP/HTTPS User Name
The user name for the HTTP/HTTPS server.
HTTP/HTTPS Password
The password for the HTTP/HTTPS server.
Firmware File Prefix
Default is blank. If configured, HT503 will request the firmware file with the prefix. This
setting is useful for ITSPs. End user should keep it blank.
Firmware File Postfix
Default is blank. End users should keep it blank.
Config File Prefix
Default is blank. End users should keep it blank.
Config File Postfix
Default is blank. End users should keep it blank.
Allow DHCP option 66 to
override server
If set to “Yes”, configuration and upgrade server information can be obtained using
DHCP option 66 from DHCP server located in customer’s environment
Automatic Upgrade
Choose “Yes” to enable automatic upgrade and provisioning. When set to No, HT503
will only do upgrade once at boot up.
When “Check every day” or “Check every week” is checked, user can specify “Hour of
the day(0-23)” or “Day of the week(0-6)”. Default time is Monday 1AM.
There are three options to choose from: “Always check for New Firmware at Boot up”,
“Check New Firmware only when F/W pre/suffix changes”, and “Always Skip the
Firmware Check”.
Authenticate Conf File
This protects the configuration from an unauthorized change. If set to “Yes, the
configuration file is authenticated before acceptance.
Firmware Key
Key for firmware encryption. (32 digits in hexadecimal format. End users should keep it
blank.
SIP TLS Certificate
The user specify SSL certificate used for SIP over TLS in X.509 format.
SIP TLS Private Key
The user specify SSL private key used for SIP over TLS in X.509 format.
SIP TLS Private Key
Password
User specify password to protect the private key above.
ACS URL
User specify the Auto Configuration Server’s URL (TR-069 protocol)
ACS Username
User specify the ACS Username
ACS Password
User specify the ACS password
Periodic Inform Enable
Default is No. If set to YES, device will send inform packets to the ACS
Periodic Inform Interval
Frequency that the inform packets will be sent out to the ACS
Connection Request
Username
Set a user name for the ACS to connect to this device
Connection Request
Password
Set a password for the ACS to connect to this device
Connection Request
Port
Set a port number for the ACS to connect to this device, default is 7547
CPE SSL Certificate
Configure the SSL authentication of Customer-premises equipment