User's Manual

FIRMWARE VERSION 1.0.7.6 HT502 USER MANUAL Page 27 of 48
DHCP hostname Default is blank. This option specifies the name of the client. This field is optional but may
be required by some Internet Service Providers.
DHCP vendor class ID Default is HT500. Used by clients and servers to exchange vendor-specific information..
PPPoE account ID
PPPoE username. Necessary if ISP requires you to use a PPPoE (Point to Point Protocol
over Ethernet) connection.
PPPoE password
PPPoE account password.
PPPoE Service Name Default is blank. This field is optional. If your ISP uses a service name for the PPPoE
connection, enter the service name here.
Time Zone
Controls how the date/time is displayed according to the specified time zone.
Self Defined Time Zone The syntax is std offset dst [offset],start[/time],end[/time]
Default is set to : MTZ+6MDT+5,M3.2.0,M11.1.0
MTZ+6MDT+5,
Time zone with 6 hours offset with 1 hour ahead which is the US central time. It is positive
(+) if the local time zone is west of the Prime Meridian and negative (-) if it is east.
Prime Meridian (a.k.a: International or Greenwich Meridian)
M3.2.0,M11.1.0
The 1
st
number indicates Month: 1,2,3,..,12 (for Jan, Feb, .., Dec)
The 2
nd
number indicates the n
th
iteration of the weekday: (1st Sunday, 3rd Tuesday etc)
The 3
rd
number indicates Weekday: 0,1, 2, ..,6(for Sun, Mon, Tue, .., Sat)
Therefore, this example is the DST which starts from the second Sunday of March to the
1st Sunday of November.
Language
Languages supported with voice prompt and web interface, except Spanish that it is only
in IVR.
Device Mode
This parameter controls whether the device is working in NAT router mode or Bridge
mode. Save the setting and reboot prior to configuring HT502.
NAT Maximum Ports
The number of ports that can be managed while in NAT router mode.
Range: 0 – 4096, default is 1024. Typically one port per connection.
NAT TCP Timeout
NAT TCP idle timeout in seconds. Connection will be closed after preconfigured, timeout
if not refreshed. Range: 0 - 3600
NAT UDP Timeout
NAT TCP idle timeout in seconds. Connection will be closed after preconfigured, timeout
if not refreshed. Range: 0 – 3600, default is 300