User's Manual

FIRMWARE VERSION 1.0.7.6 HT502 USER MANUAL Page 23 of 48
CONFIGURATIONGUIDE

CONFIGURINGTHEHT502THROUGHVOICEPROMPTS
DHCP
MODE
Select voice menu option 01 to enable HT502 to use DHCP.
STATIC
IP MODE
Select voice menu option 01 to enable HT502 to use STATIC IP mode, then use option 02, 03, 04, 05 to
set up IP address, Subnet Mask, Gateway and DNS server respectively.
F
IRMWARE SERVER IP ADDRESS
Select voice menu option 13 to configure the IP address of the firmware server.
C
ONFIGURATION SERVER IP ADDRESS
Select voice menu option 14 to configure the IP address of the configuration server.
U
PGRADE PROTOCOL
Select voice menu option 15 to choose firmware and configuration upgrade protocol. User can choose
between TFTP and HTTP.
F
IRMWARE UPGRADE MODE
Select voice menu option 17 to choose firmware upgrade mode among the following three options:
1) always check, 2) check when pre/suffix changes, and 3) never upgrade
WAN
PORT WEB ACCESS
Select voice menu option 12 to enable WAN Port Wed Access of the device configuration pages.