User manual
FIRMWARE VERSION 1.0.7.3 HT70X USER MANUAL Page 44 of 52
unwanted activation of the Flash/Hold and automatic phone ring-back, adjust this time
value. Default values are 300 minimum and 1100 maximum. HT70X
supports a
range from 40 to 2000 ms.
On Hook Timing
On-hook timing is the minimum time for an on-hook event to be validated. Default
value is 400 . HT70X supports a range from 40 to 2000 ms.
Gain
Voice path volume adjustment.
• Rx is a gain level for signals transmitted by FXS
• Tx is a gain level for signals received by FXS.
Default = 0dB for both parameters. Loudest volume: +6dB Lowest volume: -6dB.
User can adjust volume of call on either end using the Rx Gain Level parameter and
the Tx Gain Level parameter located on the FXS Port Configuration page.
If call volume is too low when using the FXS port (ie. the ATA is at user site), adjust
volume using the Rx Gain Level parameter under the FXS Port Configuration page.
If voice volume is too low at the other end, user may increase the far end volume using
the Tx Gain Level parameter under the FXS Port Configuration page.
Disable Line Echo
Canceller (LEC)
Default is No. If set to “Yes” LEC will be disabled per call base. Recommended for
FAX/Data calls.
Disable Network Echo
Suppressor
Default is No. If set to “Yes” NEC will be disabled per call base. Recommended for
FAX/Data calls.
Outgoing Call Duration
Limit
Configure the time limitation of outgoing calls. 0-180 minutes, default is 0 (No Limit).
Ring Frequency
Configure ringing frequency for your phone. 15-60 Hz, default is 20 Hz.
Enable High Ring
Power
Default is No. If it has difficulties to ring the FAX machine or phone. Enable to push
higher ring power through FXS port.
Ring Tones
This function lets you configure ring tone cadence preferences. User has 10 choices.
The configuration, completed in Distinctive Ring Tones block in the same page, applies
to ring tones cadences configured here.
TABLE 12: HT704 FXS PORTS SETTINGS
SIP Use ID
User account information, provided by VoIP service provider (ITSP). Usually in the form
of digit similar to phone number or actually a phone number.
Authenticate ID
SIP service subscriber’s Authenticate ID used for authentication. Can be identical to or
different from SIP User ID.
Password
SIP service subscriber’s account password for HT704 to register to (SIP) servers of
ITSP.