User manual

FIRMWARE VERSION 1.0.7.3 HT70X USER MANUAL Page 40 of 52
Offhook Tone
left off-hook for an extended period of time.
Disable Reminder Ring
for On-Hold Call
Default is No. Do not play the reminder ring when this is set to Yes.
Disable Visual MWI
Default is No. If set to “Yes”, the MWI information will not be transferred to the analog
phone connected to the FXS port.
Ring Timeout
Default value is 60 Sec. Incoming call will stop ringing when not picked up given a
specific period of time.
Hunting Group Ring
Timeout
Default value is 20 Sec. If call is not answered within this designated time period, the
callwill be forwarded to the next member of a Hunt Group. HT704 only
Hunting Group Type
Linear and Circular. Default is Circular. Linear style will sort the call to the lowest-
numbered available line,
this is also called “serial hunting”. Circular style will distribute
the calls "round-robin". If a
call is assigned to line 1, the next call goes to 2 and the next
to 3. The succession
throughout each of the lines continues even if one of the previous
lines becomes available. When the end of the hunt group is reached, the hunting starts
over at the firstline. Lines are skipped if they are still busy on a previous call. HT704
only
Delayed Call Forward
Wait Time
Default value is 20 seconds. In case this feature activated using * codes (*92 code),
the call will be forwarded after this preconfigured amount of time.
No Key Entry Timeout
Default is 4 seconds. Dialing process is completed and outgoing call is initiated if no
key entry occurs during this preconfigured interval.
Early Dial
Default is No. Use only if proxy supports 484 response. This parameter controls
whether the phone will send an early INVITE each time a key is pressed when a user
dials a number. If set to “Yes”, an INVITE is sent using the dial-number collected thus
far; Otherwise, no INVITE is sent until the “(Re-
)Dial” button is pressed or after about 5
seconds have elapsed if the user forgets to press the “Re-Dial” button.
The “Yes” option should be used ONLY if there is a SIP proxy configured and the proxy
server supports 484 Incomplete Address response. Othe
rwise, the call will likely be
rejected by the proxy (with a 404 Not Found error).
This feature does NOT work with and should NOT be enabled for direct IP-to-IP calling.
Dial Plan Prefix
Sets the prefix added to each dialed number.
Use # as Dial Key
Default is Yes. It allows users to configure the “#” key as the “Send” (or “Dial”) key. If
set to “Yes”, “#” will send the number. In this case, this key is essentially equivalent to
the “Dial” key. If set to “No”, this “#” key can be included as part of number.
Dial Plan
Dial Plan Rules:
1. Accept Digits: 1,2,3,4,5,6,7,8,9,0 , *, #, A,a,B,b,C,c,D,d
2. Grammar: x - any digit from 0-9;