User's Manual

FIRMWARE VERSION 1.0.0.2 GXW42XX USER MANUAL Page 41 of 52
Ring Timeout
Incoming call will stop ringing when not picked up given a specific period of time.
Hunting Group Ring
Timeout
Default is 20 seconds. If call is not answered within this designated time period, the call
will be forwarded to the next member of a Hunt Group.
Hunting Group Type
Linear and Circular. Linear style will sort the call to the lowest-numbered available line,
this is also called “serial hunting”. Circular style will distribute the calls "round-robin". If a
call is assigned to line 1, the next call goes to 2 and the next to 3. The succession
throughout each of the lines continues even if one of the previous lines becomes
available. When the end of the hunt group is reached, the hunting starts over at the first
line. Lines are skipped if they are still busy on a previous call. These two hunting styles
can be configured from the Profile_x page.
Delayed Call Forward
Wait Timeout
Default value is 20 seconds. In case this feature activated using * codes (*92 code), the
call will be forwarded after this preconfigured amount of time.
No Key Entry Timeout Default is 4 seconds. Call will be completed within this time interval if no additional key
entry occurs.
Early Dial Default is No. Use only if proxy supports 484 response. This parameter controls
whether the phone will send an early INVITE each time a key is pressed when a user
dials a number. If set to “Yes”, an INVITE is sent using the dial-number collected thus
far; Otherwise, no INVITE is sent until the “(Re-)Dial” button is pressed or after about 5
seconds have elapsed if the user forgets to press the “Re-Dial” button. The “Yes” option
should be used ONLY if there is a SIP proxy configured and the proxy server supports
484 Incomplete Address response. Otherwise, the call will likely be rejected by the proxy
(with a 404 Not Found error).
This feature is NOT designed to work with and should NOT be enabled for direct IP-to-IP
calling.
Dial Plan Prefix
Sets the prefix added to each dialed number.
Use # as Dial Key
Allows users to configure the “#” key as the “Send” (or “Dial”) key. If set to “Yes”, “#” will
send the number. In this case, this key is essentially equivalent to the “Dial” key. If set
to “No”, this “#” key can be included as part of number.