User's Manual

FIRMWARE VERSION 1.0.0.2 GXW42XX USER MANUAL Page 16 of 52

Address new IP address.

Upgrade Protocol Upgrade protocol for firmware and configuration update. Enter

“9” to toggle between TFTP and HTTP

Firmware Version Firmware version information.

Firmware Upgrade Firmware upgrade mode. Enter “9” to rotate among the following

three options:

1. always check

2. check when pre/suffix changes

3. never upgrade

“Direct IP Calling” Enter the target IP address to make a direct IP call, after dial

tone. (See “Make a Direct IP Call”.)

700-

716/724/732

Phone calls between

different ports of the same

GW42xx

User can make internal calls between different ports inside the

same GW even without being registered to SIP server. By dialing

*** and 7xx, user can reach colleague connected to port “xx”.

Voice Mail Number of voice mails

“RESET” Enter “9” to reboot the device; or

Enter MAC address to restore factory default setting

(See Restore Factory Default Setting section)

“Invalid Entry” Automatically returns to Main Menu

Five Success Tips when using the Voice Prompt

1. “*” shifts down to the next menu option

2. “#” returns to the main menu

3. “9” functions as the ENTER key in many cases to confirm an option

4. All entered digit sequences have known lengths - 2 digits for menu option and 12 digits for IP

address. For IP address, add 0 before the digits if the digits are less than 3 (i.e. - 192.168.0.26

should be key in like 192168000026. No decimal is needed).

5. Key entry can not be deleted but the phone may prompt error once it is detected



PLACINGAPHONECALL



PHONEOREXTENSIONNUMBERS

1. Dial the number directly and wait for 4 seconds (To change the default value, modify the following

setting - “No Key Entry Timeout”)