User's Manual

P a g e | 63
GXW42xx User Manual
Version 1.0.5.43
Name
Any name to identify this specific user.
Profile
Select the corresponding Profile ID (1/2/3/4)
Enable FXS
(TR-069)
Enable or disable the FXS port.
Advanced Port Settings
Offhook Auto-dial
Configure an auto dial number when Offhook.
Hunting Group
Assign this port to a certain hunting group
Request URI Routing ID
If configured, device will route the incoming call to designated port by
request URI user ID in SIP INVITE.
FXO Mapping
Map to FXO Port #
This is used only when peering with a Grandstream GXW410x. Default
1, Supported values are 1-8, meaning line 1 to 8 of the GXW410x device
where the port will be mapped to.
Map to FXO Gateway IP
This is used when peering with an FXO gateway of any brand. You have
to specifically mention the IP and sip port where call will be sent to.
Port
SIP port that will be annexed to the IP address above.
Saving the Configuration Changes
After user makes a change to the configuration, press the “Update” button in the Configuration Menu. The
web browser will then display a message window to confirm saved changes.
Grandstream recommends reboot or power cycle the gateway after saving changes.
Rebooting from Remote
Press the “Reboot” button at the bottom of the configuration menu to reboot the phone remotely. The web
browser will then display a message window to confirm that reboot is underway. Wait 30 seconds to log in
again.
Configuration through a Central Server
Grandstream GXW42XX can be automatically configured from a central provisioning system.
When GXW42XX boots up, it will send TFTP or HTTP/HTTPS requests to download configuration files,