User's Manual

P a g e | 59
GXW42xx User Manual
Version 1.0.5.43
Disable Reminder Ring for On-
Hold Call
Default is No. This is to disable the Reminder Ring that is played when
a call is waiting on hold and the analog phone goes on-hook.
Disable Voicemail Reminder
Tone
If this feature is set to yes, the reminder tone will not be played when
there is voicemail.
Disable Visual MWI
Visual message indicator is a special on-hook caller ID type message
that enables and disables the message waiting light on certain phones.
GXW42XX has this feature enabled by default. However, certain
phones (rare) that do not support it may mistakenly treat this CID signal
as an incoming call. A configuration option is needed to turn on MWI in
this case.
Visual MWI Type
This is the type of signal sent to the analog phone to make it turn the
lamp ON upon receiving a Voice mail. Check the phone’s manual to find
out what signal is supported, FSK (default) or Neon.
Transfer on Conference
Hangup
Defines whether the call is transferred to the other party if the
conference initiator hangs up.
Send Hook Flash Event
Default is No. If set to yes, flash will be sent as a DTMF event.
Flash Digit Control
Default is No. If set to Yes will overrides the default settings for call
control when both channels are in use.
• Flash+1 to hang up current call and resume call on hold
• Flash+2 to hold current call and resume call on hold
• Flash+3 for 3WC
• Flash+4 for attended transfer
Ring Timeout
Incoming call will stop ringing when not picked up given a specific period
of time.
Delayed Call Forward Wait
Timeout
Default value is 20 seconds. In case this feature activated using *
codes (*92 code), the call will be forwarded after this preconfigured
amount of time.
Send Anonymous
If this parameter is set to “Yes”, the “From” header along with Privacy
and
P_Asserted_Identity headers in outgoing INVITE message will be set to
anonymous, blocking Caller ID.