User's Manual

FIRMWARE VERSION 1.0.0.2 GXW42XX USER MANUAL Page 33 of 52
Periodic Inform Interval
Frequency that the inform packets will be sent out to the ACS
Connection Request
Username
Set a user name for the ACS to connect to this device
Connection Request
Password
Set a password for the ACS to connect to this device
System Ring Cadence
Configuration option for all FXS ports ring cadence for all incoming calls.
(Syntax: c=on1/off1-on2/off2-on3/off3; [...]) Default is set to c=2000/4000; (US
standards)
Call Progress Tones
Using these settings, user can configure tone frequencies according to user
preference. By default, the tones are set to North American frequencies. Frequencies
should be configured with known values to avoid uncomfortable high pitch sounds.
ONis the period of ringing (ON time in ms) while OFF is the period of silence. In order
to set a continuous ring, OFF should be zero. Otherwise it will ring ON ms and a pause
of OFF ms and then repeat the pattern.
• “Dial tone”
• “Ringback tone”
• “Busy/Re-order tone”
• “Confirmation tone”
Please refer the document below to determine your local call progress tones:
http://www.itu.int/ITU-T/inr/forms/files/tones-0203.pdf
Lock Keypad Update
If set to “Yes”, the configuration update via keypad is disabled.
Disable Voice Prompt
Disables the voice prompt configuration. Default is “No”. If set to “Yes” accessing
integrated voice menu will be impossible.
Disable Direct IP Call
Disables the Direct IP Call function. Default is “No”. If set to “Yes” direct IP-to-IP
calling will not be supported.
Failover to FXO Gateway
This feature allows users to place an outbound PSTN call in case there is a loss of an
active registration (SIP server unreachable) of all FXS profiles. If set to “YES”, when
GXW42XX recognizes a loss of registration, all outgoing calls will be routed to an FXO
gateway.
The use of this option presumes a configured GXW410x or another FXO gateway with
an active PSTN line connection.
FXO Gateway
IP Address or URI of the FXO gateway.
NTP server
URI or IP address of the NTP (Network Time Protocol) server. Used by the phone to
synchronize the date and time. An extensive list of public NTP servers can be found at
http://www.ntp.org