User's Manual

FIRMWARE VERSION 1.0.0.2 GXW42XX USER MANUAL Page 32 of 52
Config File Prefix
Default is blank. This setting is useful for Internet Telephone Service Providers. End
users should keep it blank.
Config File Postfix
Default is blank. This setting is useful for Internet Telephone Service Providers. End
users should keep it blank.
Allow DHCP Option 66 to
override server
If set to “Yes”, configuration and upgrade server’s information can be obtained using
DHCP option 66 from DHCP server. This option specifies the URL of the tftp server.
Note: If DHCP Option 66 is enabled, the gateway will attempt downloading a
configuration file from the server URL provided by DHCP, even though Config Server
Path is left blank.
Automatic Upgrade
Choose “Yes” to enable automatic upgrade and provisioning. When set to No,
GXW42XX will only do upgrade once at boot up.
When “Yes, daily at hour ___” or “Yes, weekly on day ___” is checked, user can
specify “Hour of the day (0-23)” or “Day of the week (0-6)”. Default time is Monday
1AM.
When “Yes, Yes, every ___ minutes” is checked, user can specify the time interval
between each upgrade check. Default is 10080 minutes.
There are three options to choose from: “Always check for New Firmware at Boot up”,
“Check New Firmware only when F/W pre/suffix changes”, and “Always Skip the
Firmware Check”.
Authenticate Conf File
If set to Yes, configuration file is authenticated before being accepted. This protects the
configuration from unauthorized modifications.
Firmware Key
For firmware encryption. It should be 32-digit in Hexadecimal Representation. End
user should keep it blank.
SSL Certificate
The GXW42XX series supports SIP over TLS. It has built-in private key and SSL
certificate. The user specified SSL certificate used for SIP over TLS is in X.509 format.
SSL Private Key
You may also customize the SSL Private Key. The user specified SSL private key used
for SIP over TLS is in X.509 format.
SSL Private Key
Password
Enter SSL Private Key password here.
ACS URL
User specify the Auto Configuration Server’s URL (TR-069 protocol)
ACS Username
User specify the ACS Username
ACS Password
User specify the ACS password
Periodic Inform Enable
Default is No. If set to YES, device will send inform packets to the ACS