User Guide

TABLE 12: CHANNELS PAGE DEFINITIONS
Dial Plan
The Dial Plan feature implemented is applicable for VOIP to PSTN calls only. You may
configure a dial plan based on the following grammar:
1. Accept Digits: 1,2,3,4,5,6,7,8,9,0,*,#,A,a,B,b,C,c,D,d
2. Grammar:
x - any digit from 0-9;
xx+ - at least 2 digit number;
xx. - at least 2 digit number;
^ - exclude;
[3-5] - any digit of 3, 4, or 5;
[147] - any digit 1, 4, or 7;
<2=011> - replace digit 2 with 011 when dialing
WARNING - illegal input will fall back to default
Example 1: {[369]11 | 1617xxxxxxx} - Allow 311, 611, 911, and any 10 digit
numbers of leading digits 1617.
Example 2: {^1900x+ | <=1617>xxxxxxx} - Block any number of leading digits 1900
and add prefix 1617 for any dialed 7 digit numbers.
Example 3: {1xxx[2-9]xxxxxx | <2=011>x+} - Allow any length of number with
leading digit 2 and 10 digit-numbers of leading digit 1 and leading exchange number
between 2 and 9;
If leading digit is 2, replace leading digit 2 with 011 before dialing
Default: PSTN Outgoing - {x+}
Note: If you do not plan to use this feature set to default {x+}
Hook flash Duration
(X10ms)
Default 600ms. This value can accept any value in the 100-2000ms range.
Use DTMF Parameter
from RFC2833 or SIP Info
Default Yes, No means to use DTMF parameter settings according to DTMF Digit
Length, DTMF Digit Volume and DTMF Dial Pause.
DTMF Digit Length
Default value is 100ms. Please not that the value will be multiplied by 10ms
DTMF Digit Volume
Default value is -11dB.
DTMF Dial Pause
Default value is 100ms. Please note that the value will be multiplied by 10ms.
PROFILES
Profiles are basically IP-PBX / SIP Server configuration templates. If you have more than one IP-PBX
system or SIP Server that you would like to use with the GXW410x, then you can configure Profile 2 or 3.
Note: Make sure you select the correct profile for each channel under Channels PAGE
TABLE 13: PROFILE PAGE DEFINITIONS
Activate Profile
When set to Yes the SIP Profile is activated.
Profile Name
A name to identify a Profile.