User's Manual

Grandstream Networks, Inc. GXV3140H USER MANUAL Page 48 of 146
FIRMWARE VERSION 1.0.7.2 Updated : 11/2010
3. Default: Outgoing – {x+}
Allow any length of numbers.
Example of a simple dial plan used in a Home/Office in the US:
{ ^1900x. | <=1617>[2-9]xxxxxx | 1[2-9]xx[2-9]xxxxxx | 011[2-9]x. |
[3469]11 }
Explanation of example rule (reading from left to right):
• ^1900x. - prevents dialing any number started with 1900
• <=1617>[2-9]xxxxxx - allows dialing to local area code (617) numbers by
dialing
7 numbers and 1617 area code will be added automatically
• 1[2-9]xx[2-9]xxxxxx |- allows dialing to any US/Canada Number with 11
digits
length
• 011[2-9]x. - allows international calls starting with 011
• [3469]11 - allow dialing special and emergency numbers 311, 411, 611
and 911
NOTE: In some cases where the user wishes to dial strings such as *123 to
activate voice mail or other applications provided by their service provider,
the * should be predefined inside the dial plan feature. An example dial
plan will be: { *x+ } which allows the user to dial * followed by any length of
numbers.
Early Dial The default setting is NO. Use only if the proxy supports 484 response.
Refer to Use Target
Contact
The default is NO. If set to YES, then for Attended Transfer, the “Refer-To”
header uses the transferred target’s contact header information.
Auto Answer The default setting is NO. If it is set to YES, the GXV3140H will play a
“beep” sound and answer the phone automatically on the speaker.
Send Anonymous If set to YES, the “From” header in the outgoing SIP messages will be set
to anonymous to block the caller ID from displaying. The default setting is
NO.
Anonymous Call Rejection
The default setting is NO；If set to YES，any anonymous call will be rejected
（with 486 Busy message）
Special Feature Different soft switch vendors have special requirements; therefore users
may need to select special features to meet these requirements. Users can
choose from Standard, CBCOM, RNK, China Mobile, ZTE IMS and Mobotix
depending on their need.
The default setting is Standard.
Enable Call Features The default is set to YES. If it is set to NO, call features are disabled.
Call Forward Unconditional Sets the number to forward to unconditionally.