User's Manual

Grandstream Networks, Inc. GXV3140H USER MANUAL Page 43 of 146
FIRMWARE VERSION 1.0.7.2 Updated : 11/2010
NOTE: To use OpenVPN functionalities, users must enable OpenVPN and configure all of the settings
related to OpenVPN, including server address, port, OpenVPN CA, certificate and key. Additionally, the
user must also set the SIP account to use “VPN” for the “Nat Traversal” (under Account-> Network
Settings). Reboot the phone after these settings are saved for the changes to take effect. Once the phone
connects to the OpenVPN server and the authentication is correct, the phone will show the VPN IP
address under the Status-> Network Status, but it will still display the LAN IP on the LCD of the phone.
SIP ACCOUNT CONFIGURATION PAGE DEFINITIONS
The GXV3140H has three lines that can be configured to accommodate independent SIP accounts. Every
SIP account has an individual configuration page.
Account/General Settings
Account Active Select YES to enable and use the Line.
Account Name The account name for the user that is displayed on the LCD screen.
SIP Server The IP address of the SIP server or the given domain name of the VoIP
service provider.
SIP User ID User account information provided by the VoIP service provider; normally
similar to a telephone number or an actual telephone number.
Authenticate ID The authenticate ID for the SIP user. It can differ or be the same as the SIP
user ID.
Authenticate password The password that the GXV uses to authenticate with the ITSP (SIP)
server. After it is saved, this will appear as blank for security reasons. The
maximum length is 25 characters.
Voice Mail User ID When this is configured, the user can dial to the voicemail server using the
MESSAGE button. This ID is normally the feature code for Voice Mail.
Name The Caller ID that will be displayed for the account.
User ID is phone number: If the Video phone has an assigned PSTN number, this field should be set
to “YES”. Otherwise, set it to “NO”. If “YES” is set, a “user=phone”
parameter will be attached to the “From header” in the SIP request to
indicate the E.164 number.
Account/Network Settings
Outbound Proxy IP address or Domain name of the Outbound Proxy, or Media Gateway, or
Session Border Controller. Used by the GXV3140H for firewall or NAT
penetration in different network environments. If a symmetric NAT is
detected, STUN will not work and ONLY an Outbound Proxy will work.