User manual

FIRMWARE VERSION 1.0.1.38 GXV3175V2 USER MANUAL Page 71 of 138
The second option of creating BLFs would be using an Eventlist (must be created in SIP server first). To
access Event-List BLF, access the same BLF settings screen, and select the “URI” tab at the top
(Figure 45).
Figure 45: Event-list Settings Screen(URI)
Same as setting up the BLF list, but in this configuration, the user will need to enter an “Event List URI”
which is created on the server side. It is possible that the Event-list was created with multiple extensions
so there is an option called “Follow All Extensions”, which allows the user to monitor all extensions under
the given Event-List. If “Following All Extensions” is selected, press the ‘X’ at the top right to return to the
BLF screen to see the monitored extensions (See Figure 42). If following all extensions is not desired,
the user may add specific extensions from the eventlist.
Direct IP Call is also supported via BLF by specifying an IP address as an Extension.
BLF Status
The GREEN outlining shows that the user is available.
The RED outlining shows a status of busy/on call.
If status is shows BLINKING RED, it means that the extension is receiving
an incoming call.
The GRAY outlining shows a status of a user unregistered. With this status
the user is unable to monitor the extension.