User's Manual

FIRMWARE VERSION 1.0.0.3 GXP2140 USER MANUAL Page 55 of 77
last answered call.
 Transfer
Select Account, and enter the number in the Value field to be
transferred (blind transfer) during the call.
 Call Park
Select Account, and enter the call park extension in the Value field to
park/pick up the call.
 Intercom
Select Account, and enter the extension number in the Value field to
do the intercom.
 LDAP Search
This option is to narrow the LDAP search scope. Enter the LDAP
search base in the Name field. It could be the same or different from
the Base in LDAP configuration under Advanced Settings. The Base
in LDAP configuration will be used if the Name field is left blank.
Enter the LDAP Name/Number filter in the Value field. LDAP search
does not support entering Non-ASCII characters
 Multicast Paging
Select Account, and enter the IP address with port number in the
Value field where the multicast paging will be sent to.
 Record
Select Account, and enter the extension number for recording.
Extension Boards(Only for
GXP2140)
Assigns a function to the corresponding Multi Purpose Key. The key
mode options are:
 Speed Dial
Select the Account to dial from. And enter the Speed Dial number in
the Value field to be dialed.
 BLF (Busy Lamp Field)
This option has to be supported on the PBX and it indicates the
status of the extension. The three possible states are idle (green),
busy (red), ringing (blinking red).
 Presence Watcher
This option has to be supported by a presence server and it is tied to
the "Do Not Disturb" status of the phone's extension.
 Eventlist BLF
This option is similar to the BLF option but in this case the PBX
collects the information from the phones and sends it out in one
single notify message. PBX server has to support this feature.
 Speed Dial via active account