User's Manual

FIRMWARE VERSION 1.0.0.3 GXP2140 USER MANUAL Page 50 of 77
is "No".
Disable Direct IP Call
Disables Direct IP Call. The default setting is "No".
Use Quick IP Call mode
When set to "Yes", users can dial an IP address under the same
LAN/VPN segment by entering the last octet in the IP address. To dial
quick IP call, off hook the phone and dial #XXX (X is 0-9 and XXX
<=255), phone will make direct IP call to aaa.bbb.ccc.XXX where
aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet
mask. #XX or #X are also valid so leading 0 is not required (but OK). No
SIP server is required to make quick IP call. The default setting is "No".
Disable Conference
Disables the Conference function. The default setting is "No".
Disable in-call DTMF Display
When it's set to "Yes", the DTMF digits entered during the call will not
display. The default setting is "No".
Enable sending DTMF via
Speed Dial
Enables Multi Purpose Key to send DTMF during the call. The default
setting is "No".
Disable DND Button
If set to "Yes", the DND button will not set the phone to DND. The default
setting is "No".
Enable Idle Mute
If this feature is enabled, MUTE key will take effect in idle state and future
incoming call will be answered with mute.
Disable Transfer
Disables the Transfer function. The default setting is "No".
In-call dial number on pressing
transfer key
Configures the number for the phone to dial as DTMF during the call
using TRAN button.
Auto-Attended Transfer
If set to "Yes", the phone will use attended transfer by default. The default
setting is "No".
Do Not Escape # as %23 in
SIP URI
Specifies whether to replace # by %23 or not for some special situations.
The default setting is "No".
Click-To-Dial Feature
Enables Click-To-Dial feature. The default setting is "Disabled".
Call History Flash Writing:
Write Timeout
Defines the interval (in seconds) to save the call history to phone's flash.
The default value is 300 seconds.
Call History Flash Writing:
Max Unsaved Log
Defines the number of unsaved logs before written to phone's flash. The
default value is 200 entries.
Settings -> Multicast Paging
Paging Barge
During active call if incoming multicast page is higher than this value, the
call will be held and multicast page will be played.
Paging Priority Active
If enabled, during a multicast page if another multicast page is received
with higher priority the one the one will be played instead.
Multicast Paging Codec
The codec for sending multicast pages.