User's Manual
GXP2130/GXP2140/GXP2160/GXP2170/GXP2135
ADMINISTRATION GUIDE
Page 47 of 85
Always Ring Speaker
Configures to enable or disable the speaker to ring when headset is used
on "Toggle Headset/Speaker" mode. If set to "Yes", when the phone is in
Headset "Toggle Headset/Speaker" mode, both headset and speaker will
ring on incoming call. The default setting is "No".
Headset TX gain
Configures the transmission gain of the headset. The default value is
0dB.
Headset RX gain
Configures the receiving gain of the headset. The default value is 0dB.
Handset TX gain
Configures the transmission gain of the handset. The default value is
0dB.
Settings LCD Display
Backlight Brightness: Active
Configures the LCD brightness when the phone is active. Valid range is
10 to 100 where 100 is the brightest. Default value is 100.
Backlight Brightness: Idle
Configures the LCDbrightness when the phone is idle. Valid range is 10
to 100 where 0 is off and 100 is the brightest. Default value is 60.
Disable Missed Call Backlight
If set to "Yes", the screen will turn off the LCD backlight when there is a
missed call on the phone. The default setting is "No".
Wallpaper Source
Specifies the wallpaper source mode: Default, Download, USB and
Uploaded.User could upload a wallpaper source into your phone, or
download it from file server with the server path, or plug your USB drive
with wallpaper source into GXP2140/2160 to upload the wallpaper.
Note: USB is only for GXP2140/GXP2160.
Wallpaper Server Path
Specifies the wallpaper server path. This option will take effect when
wallpaper source is “Download”.
Upload Wallpaper
Click on the “Upload” button to browse and upload the desired wallpaper
file. This option will take effect when wallpaper source is “Uploaded”.
Screensaver
Disable/Enable Screensaver. By default, screensaver is enabled.
Screensaver Source
This option is used for users to set the location where screensaver is
loaded from. If from USB, please have a folder named “screensavers”
containing your pictures.
Screensaver Timeout
Configures the minutes of idle before the screensaver activates. Valid
range is 3 to 6. The default time is 3 minutes.
Settings LCD Control
BLF LED Pattern
This is used to configure the color and pattern of the LED based on
status updates. The default setting is “Default”.
The BLF LED Patterns are listed in the following Table 13.
Settings Date and Time
NTP Server
Defines the URL or IP address of the NTP server. The phone may obtain