User's Manual

ManualsBrandsGrandstream Networks ManualsElectronicsIP Phone

GXP2130/GXP2140/GXP2160/GXP2170/GXP2135

ADMINISTRATION GUIDE

Page 43 of 85

Call Forward

Unconditionally (All)--On

Configures Call Forward All feature code to activate unconditional call

forwarding.

Call Forward

Unconditionally (All)--Off

Configures Call Forward All feature code to deactivate unconditional call

forwarding

Call Forward Busy--On

Configures Call Forward Busy feature code to activate busy call forwarding.

Call Forward Busy--Off

Configures Call Forward Busy feature code to deactivate busy call forwarding.

Call Forward Delayed

(No Answer)--On

Configures Call Forward Delayed feature code to activate no answer call

forwarding.

Call Forward Delayed

(No Answer)--Off

Configures Call Forward Delayed feature code to activate no answer call

forwarding.

Delayed Call Forward

Wait Time

Defines the timeout (in seconds) before the call is forwarded on no answer.

The default value is 20 seconds. The valid range is 1 to 120.

SETTINGS PAGE DEFINITIONS

Table 11: Settings Page Definitions

Settings  General Settings

Local RTP Port

This parameter defines the local RTP port used to listen and transmit. It

is the base RTP port for channel 0. When configured, channel 0 will use

this port _value for RTP; channel 1 will use port_value+2 for RTP. Local

RTP port ranges from 1024 to 65400 and must be even. The default

value is 5004.

Use Random Port

When set to "Yes", this parameter will force random generation of both

the local SIP and RTP ports. This is usually necessary when multiple

phones are behind the same full cone NAT. The default setting is "Yes"

Note:This parameter must be set to "No" for Direct IP Calling to work.

Keep-alive Interval

Specifies how often the phone sends a blank UDP packet to the SIP

server in order to keep the "ping hole" on the NAT router to open. The

default setting is 20 seconds. The valid range is from 10 to 160.

Use NAT IP

The NAT IP address used in SIP/SDP messages. This field is blank at

the default settings. It should ONLY be used if it's required by your ITSP.

STUN Server

The IP address or Domain name of the STUN server. STUN resolution

results are displayed in the STATUS page of the Web GUI. Only

non-symmetric NAT routers work with STUN.

Public Mode

Configures to turn on/off the public mode for hot desking feature. The

default setting is “No”.