User's Manual

GXP2130/GXP2140/GXP2160/GXP2170/GXP2135
ADMINISTRATION GUIDE
Page 42 of 85
Allow Auto Answer by
Call-Info
If set to "Yes", the phone will automatically turn on the speaker phone to
answer incoming calls, based on the SIP info header sent from the
server/proxy. The default setting is "No".
Allow Barging by
Call-Info
When it is enabled, the phone will put the current call on hold automatically
and answer the incoming calls based on the SIP Call-Info header sent from the
server/proxy. However, if the current call was answered based on the SIP
Call-Info header, then all other incoming calls with SIP Call-Info headers will be
rejected automatically. The default setting is “No”.
Custom Call-Info for Auto
Answer
Used in addition to match the contents of the info parameter in the Call-Info
header for auto answer.
Refer-To Use Target
Contact
If set to "Yes", the "Refer-To" header uses the transferred target's Contact
header information for attended transfer. The default setting is "No".
Transfer on Conference
Hangup
If set to "Yes", when the phone hangs up as the conference initiator, the
conference call will be transferred to the other parties so that other parties will
remain in the conference call. The default setting is"No".
Disable Recovery on
Blind Transfer
Disable recovery to the call to the transferee on failing blind transfer to the
target. The default setting is “No”.
No Key Entry Timeout(s)
Defines the timeout (in seconds) for no key entry. If no key is pressed after the
timeout, the digits will be sent out. The default value is 4 seconds. The valid
range is from 1 to 15.
Use # as Dial Key
Allows users to configure the "#" key as the "Send" key. If set to "Yes", the "#"
key will immediately dial out the input digits. In this case, this key is essentially
equivalent to the "Send" key. If set to "No", the "#" key is included as part of the
dialing string and please make sure the dial plan is properly configured to allow
dialing # out. The default setting is “Yes”.
On Hold Reminder Tone
If set to “Enabled”, phone will play a reminder tone when it has a call on hold.
The default setting is “Disabled”.
Account x Feature Codes
Enable Local Call
Features
When enabled, Do No Disturb, Call Forwarding and other call features can be
used via the local feature codes on the phone. Otherwise, the provisioned
feature codes from the server will be used. User configured feature codes will
be used only if server provisioned feature codes are not provided. And once
feature codes are configured, either via server provisioning or local setting, a
softkey named “Features”will show on the LCD screen.
Do Not Disturb
(DND)--On
Configures DND feature code to turn on DND.
Do Not Disturb
(DND)--Off
Configures DND feature code to turn off DND.