User's Manual
FIRMWARE VERSION 1.0.1.14      GXP2130/GXP2140/GXP2160 USER MANUAL   Page 59 of 84 
Call Progresses Tones: 
System Ring Tone 
Dial Tone 
Message Waiting 
Ring Back Tone 
Call-Waiting Tone 
Busy Tone 
Reorder Tone 
Configures  ring  or  tone  frequencies  based  on  parameters  from  local 
telecom.  The  default  value  is  North  American  standard.  Frequencies 
should  be  configured  with  known  values  to  avoid  uncomfortable  high 
pitch sounds. 
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];   
(Frequencies are in Hz and cadence on and off are in 10ms)   
ON is the period of ringing (“On time” in ‘ms’) while OFF is the period of 
silence. In order to set a continuous ring, OFF should be zero. Otherwise 
it will ring ON ms and a pause of OFF ms and then repeat the pattern. Up 
to three cadences are supported. 
Call Waiting Tone Gain 
Configures the call waiting tone gain to adjust call waiting tone volume. 
The default setting is "Low". 
Settings -> Audio Control 
Headset Key Mode 
When headset is connected to the phone, users could use the HEADSET 
button in "Default Mode" or "Toggle Headset/Speaker". 
  Default Mode: 
  When the phone is in idle, press HEADSET button to off hook 
the phone and make calls by using headset. Headset icon will 
display on the screen in dialing/talking status. 
  When there is an incoming call, press HEADSET button to pick 
up the call using headset. 
  When  there  is  an  active  call  using  headset,  press  HEADSET 
button to hang up the call. 
  When Speaker/Handset  is  being  used  in  dialing/talking  status, 
press HEADSET button to switch to headset. Press it again to 
hang up the call. Or press speaker/Handset to switch back to the 
previous mode. 
  Toggle Headst/Speaker: 
  When the phone is in idle, press HEADSET button to switch to 
Headset mode. The headset icon will display on the left side of 
the screen. In this mode, if pressing Speaker button or Line key 
to off hook the phone, headset will be used. 
  When there is an active call, press HEADSET button to toggle 
between Headset and Speaker. 
Headset Type 
Selects normal RJ9 headset or Plantronics EHS headset for the headset 
type. 










