User manual

FIRMWARE VERSION 1.0.5.15 GXP2124 USER MANUAL Page 58 of 71
to override SIP Server phone. The default setting is "No".
Automatic Upgrade Enables automatic upgrade and provisioning. The default setting is "No".
Hour of the Day (0-23)
Defines the hour of the day to check the HTTP/TFTP server for firmware
upgrades or configuration files changes. The default value is 1.
Day of the Week (0-6)
Defines the day of the week to check HTTP/TFTP server for firmware
upgrades or configuration files changes. The default value is 1.
Authenticate Conf File Authenticates configuration file before acceptance. The default setting is "No".
Maintenance -> Syslog
Syslog Server The URL or IP address of the syslog server for the phone to send syslog to.
Syslog Level
Selects the level of logging for syslog. The default setting is "None". There are
4 levels: DEBUG, INFO, WARNING AND ERROR.
Syslog messages are sent based on the following events:
• product model/version on boot up (INFO level);
• NAT related info (INFO level);
• sent or received SIP message (DEBUG level);
• SIP message summary (INFO level);
• inbound and outbound calls (INFO level);
• registration status change (INFO level);
• negotiated codec (INFO level);
• ethernet link up (INFO level);
• SLIC chip exception (WARNING and ERROR levels);
• memory exception (ERROR level).
Send SIP Log
Configures whether the SIP log will be included in the s
yslog messages or not.
The default setting is "No".
Auto Recover From
Abnormal
Configures whether auto recover or not wh
en the phone is running abnormal.
The default setting is "Yes".
Maintenance -> Language
Display Language Selects display language on the phone.
Language File Postfix Specifies the language file postfix for downloaded language.
Maintenance -> TR-069
Enable TR-069 Enables TR-069. The default setting is "No".
ACS URL URL for TR-069 Auto Configuration Servers (ACS).
TR-069 Username ACS username for TR-069.
TR-069 Password ACS password for TR-069.
Periodic Inform Enable
Enables periodic inform. If set t
o "Yes", device will send inform packets to the
ACS. The default setting is "No".