User manual

FIRMWARE VERSION 1.0.5.15 GXP2124 USER MANUAL Page 55 of 71
Select Account, and enter the extension number in the Value field to
do the intercom.
• LDAP Search
This option is to narrow the LDAP search scope. Enter the LDAP
search base in the Name field.
It could be the same or different from
the Base in LDAP configuration under Advanced Settings. The Base
in LDAP configuration will be used if the Name field is left blank.
Enter the LDAP Name/Number filter in the Value field.
NETWORK PAGE DEFINITIONS
Network -> Basic Settings
Internet Protocol Selects Prefer IPv4 or Prefer IPv6.
IPv4 Address Type
Allows users to configure the appropriate network settings on the phone
to obtain IPv4 address
. Users could select "DHCP", "Static IP" or
"PPPoE". By default, it is set to "DHCP".
DHCP Host name (Option 12)
Specifies the name of the client. This field is optional but may be required
by some Internet Service Providers.
DHCP Vendor Class ID
(Option 60)
Used by clients and servers to exchange vendor class ID.
PPPoE Account ID Enter the PPPoE account ID.
PPPoE Password Enter the PPPoE Password.
PPPoE Service Name Enter the PPPoE Service Name.
IPv4 Address Enter the IP address when static IP is used.
Subnet Mask Enter the Subnet Mask when static IP is used for IPv4.
Gateway Enter the Default Gateway when static IP is used for IPv4.
DNS Server 1 Enter the DNS Server 1 when static IP is used for IPv4.
DNS Server 2 Enter the DNS Server 2 when static IP is used for IPv4.
Preferred DNS Server Enter the Preferred DNS Server for IPv4.
IPv6 Address Type
Allows users to configure the appropriate network settings on the phone
to obtain IPv6 address. Users could select "Auto-
configured" or
"Statically configured" for the IPv6 address type.
Static IPv6 Address
Enter the static IPv6 address when Full Static is used in "Statically
configured" IPv6 address type.
IPv6 Prefix Length
E
nter the IPv6 prefix length when Full Static is used in "Statically
configured" IPv6 address type.