User manual

FIRMWARE VERSION 1.0.5.15 GXP2124 USER MANUAL Page 49 of 71
In-call dial number on pressing
transfer key
Configures the number for the phone
to dial as DTMF during the call
using TRAN button.
Auto-Attended Transfer
If set to "Yes", the phone will use attended transfer by default. The default
setting is "No".
Do Not Escape # as %23 in
SIP URI
Specifies whether to replace # by %23 or not for some special situations.
The default setting is "No".
Click-To-Dial Feature Enables Click-To -Dial feature. The default setting is "Disabled".
Call History Flash Writing:
Write Timeout
Defines the interval (in seconds) to save the call history to phone's flash.
The default value is 300 seconds.
Call History Flash Writing:
Max Unsaved Log
Defines the number of unsaved logs before written to phone's flash. The
default value is 200 entries.
Settings -> Ring Tone
Call Progresses Tones:
System Ring Tone
Dial Tone
Message Waiting
Ring Back Tone
Call-Waiting Tone
Busy Tone
Reorder Tone
Configures ring or tone frequencies based on pa
rameters from local
telecom. The default value is North American standard. Frequencies
should be configured with known values to avoid u
ncomfortable high
pitch sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing (“On time” in ‘ms’) while OFF is the period of
silence. In order to set a continuous ring, OFF should be zero. Otherwise
it will ring ON ms and a pause of OFF ms and then repeat the pattern. Up
to three cadences are supported.
Call Waiting Tone Gain
Configures the call waiting tone gain to adjust call waiting tone volume.
The default setting is "Low".
Settings -> Audio Control
Headset Key Mode
When headset is connected to the phone, users could use the HEADSET
button in "Default Mode" or "Toggle Headset/Speaker".
• Default Mode:
 When the phone is in
idle, press HEADSET button to off hook
the phone and make calls by using headset. Headset icon will
display on the screen in dialing/talking status.

When there is an incoming call, press HEADSET button to pick
up the call using headset.
 When there is an ac
tive call using headset, press HEADSET
button to hang up the call.

When Speaker/Handset is being used in dialing/talking status,