User's Manual

P a g e | 25
GXP17xx Administration Guide
"No", the P-Preferred-Identity Header will not show in INVITE.
Add Auth Header on
Initial REGISTER
To define whether authorization Header will be added on initial REGISTER
from the first REGISTER. The default setting is “No”.
Allow SIP Reset
This is used to perform a factory reset through SIP NOTIFY. When the phone
receives the NOTIFY with event: RESET, the phone should perform a factory
reset after the authentication. The default setting is “No”.
Account x  SIP Settings  Advanced Features
Line Seize Timeout
For Shared Call Appearance, phone must send a SUBSCRIBE-request for
the line-seize event package whenever a user attempts to take the shared
line off hook. “Line Seize Timeout” is the line-seize event expiration timer. The
default value is 15 seconds. The valid range is from 15 to 60.
Eventlist BLF URI
Configures the eventlist BLF URI on the phone to monitor the extensions in
the list with Multi-Purpose Key. If the server supports this feature, users need
to configure an eventlist BLF URI on the service side first (i.e.,
[e-mail]) with a list of extension included. On the phone, in
this "eventlist BLF URI" field, fill in the URI without the domain (i.e.,
BLF1006). To monitor the extensions in the list, under Web
GUI->Settings->Programmable Keys page, please select "eventlist BLF" in
the key mode, choose account, enter the value of each extension in the list.
Auto Provision Eventlist
BLFs
When option is enabled, empty multi-purpose keys will be automatically
provisioned to the monitored extensions in the Eventlist BLF. The default
setting is “Disabled”.
Conference URI
Configures Conference URI for N-way conference (Broadsoft Standard).
Music On Hold URI
Configures Music On Hold URI to call when a call is on hold. This feature has
to be supported on the server side.
Force BLF Call-pickup
by prefix
Configures to always use the prefix for BLF Call-pickup. The default setting is
“No”.
BLF Call-pickup Prefix
Configures the prefix prepended to the BLF extension when the phone picks
up a call with BLF key. The default setting is **.
PUBLISH for Presence
Enables presence feature on the phone. The default setting is "No".
Omit charset=UTF-8 in
MESSAGE
Omit charset=UTF-8 in MESSAGE content-type
Special Feature
Different soft switch vendors have special requirements. Therefore, users
may need select special features to meet these requirements. Users can
choose from Standard, Nortel MCS, Broadsoft, CBCOM, RNK, Sylantro,
Huawei IMS and PhonePower depending on the server type. The default
setting is "Standard".
Broadsoft Call Center
Default setting is "No". When set to "Yes", a soft key “BSCCenter” is