User's Manual

P a g e | 24
GXP17xx Administration Guide
SIP Transport
Determines the network protocol used for the SIP transport. Users can
choose from TCP, UDP and TLS. The default setting is “UDP”.
SIP URI Scheme when
using TLS
Specifies if "sip" or "sips" will be used when TLS/TCP is selected for SIP
Transport. The default setting is "sips".
Use Actual Ephemeral
Port in Contact with
TCP/TLS
This option is used to control the port information in the Via header and
Contact header. If set to No, these port numbers will use the permanent
listening port on the phone. Otherwise, they will use the ephemeral port for the
particular connection. The default setting is “No”.
Remove OBP from route
Configures to remove outbound proxy from route. This is used for the SIP
Extension to notify the SIP server that the device is behind a NAT/Firewall.
The default setting is "No".
Support SIP Instance ID
Defines whether SIP Instance ID is supported or not. The default setting is
"Yes".
SUBSCRIBE for MWI
When set to "Yes", a SUBSCRIBE for Message Waiting Indication will be sent
periodically. The phone supports synchronized and non-synchronized MWI.
The default setting is "No".
SUBSCRIBE for
Registration
When set to "Yes", a SUBSCRIBE for Registration will be sent out
periodically. The default setting is "No".
Enable 100rel
The use of the PRACK (Provisional Acknowledgment) method enables
reliability to SIP provisional responses (1xx series). This is very important in
order to support PSTN internetworking. To invoke a reliable provisional
response, the 100rel tag is appended to the value of the required header of
the initial signaling messages. The default setting is "No".
Caller ID Display
When set to "Auto", the phone will look for the caller ID in the order of
P-Asserted Identity Header, Remote-Party-ID Header and From Header in
the incoming SIP INVITE. When set to "Disabled", all incoming calls are
displayed with "Unavailable". When set to "From Header", the phone will
display the caller ID based on the From Header in the incoming SIP INVITE.
The default setting is "Auto".
Use Privacy Header
Controls whether the Privacy header will present in the SIP INVITE message
or not, whether the header contains the caller info. When set to "Default", the
Privacy Header will show in INVITE only when "Huawei IMS" special feature
is on. If set to "Yes", the Privacy Header will always show in INVITE. If set to
"No", the Privacy Header will not show in INVITE. The default setting is
"Default".
Use P-Preferred-Identity
Header
Controls whether the P-Preferred-Identity Header will present in the SIP
INVITE message. The default setting is "default": the P-Preferred-Identity
Header will show in INVITE unless "Huawei IMS" special feature is on. If set
to "Yes", the P-Preferred-Identity Header will always show in INVITE. If set to